LED Conversion Lamps

The LED tail lights were specifically designed for Ghosts and are fundamentally different than commercially available LED units. The separate voltage regulator provides the correct voltage to the LED unit for optimum brightness for both ‘tail’ and ‘stop / turn’ functions with a widely varying input voltage. The special design accommodates the Ghost electrical system that may have at one extreme very low voltage at night with the lights on and the engine idling, and the other extreme where the voltage is quite high during the day with the lights off and the engine running very fast. Above are parts for conversion of Ghost tail lights to LEDs. See the Tourer articles printed the 4th quarter of 1999 (99-4) and 2nd quarter of 2000 (00-2). While these units can be built for either 6 or 12 volt cars, they can only be used on negative ground cars. Hence some cars must have their polarity changed to use the LED lights. Note the following: 1) the lamps cannot be used without the regulator above; 2) a single regulator can operate up to four LED lamp assemblies; 3) two regulators are required for turn signals on the back of the car.

Axial Lamp Indexed Offset Pins Part No. M1401

Radial Lamp Indexed Offset Pins Part No. M1402

Axial Lamp Non-Indexed Straight Pins Part No. M1431

Radial Lamp Non-Indexed Straight Pins Part No. M1432

6 Volt Regulator Part No. M1502-02

12 Volt Regulator Part No. M1501-02